Rather than buying a whole quick release system, I was hoping I could use my same quick release from my tripod (QSX - Digipro 8500) and just b. Your bolt needs to be long enough to go through your tripod mount and then into your camera.įYI- The "1/4-20" designation means that the bolt is 1/4 inch in diameter, with a thread "pitch" of 20 threads per inch. UPC 081097290727 buy Quantaray 291660728 Quantaray Qsx Digi Pro 100 Tripod 081097290727 Learn about Quantaray UPC lookup, find upc. I've built a little homemade steady cam that I want to add a quick release to so I don't have to screw/unscrew my camera to/from it all the time. ![]() You can also add a 1/4 inch flat washer to keep the nut off your camera's finish. Good sturdy tripod with features that make sense Reviewed in the United States on December 3, 2006. You only need to have the bolt screw into your camera about 1/4" to secure it. Along with your bolt purchase, get a matching 1/4-20 nut to act as a backstop so you do not screw it in too far. Too long, and overtightening can damage your camera. THE most IMPORTANT thing is choosing the correct length. It was only 59.99, which I suppose is quite cheap in comparison to Gitzos and Manfrottos. Places like Home Depot have large bins with just about every type bolt imaginable. UPDATE: To all or any who may find this of interest, I got the Quantaray DigiPro 8500. You can go to any hardware store and find a huge selection.many will even have a knurled knob on the end for hand-tightening. What you require is a 1/4-20 bolt of any type. Good news! You can fix this very easily! The threads for tripod to camera mounting have been standardized for decades!
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |